Channel Mode 1483 Bridged should be selected.The Next Changes Should Apply as below for SETUP page WAN configuration Section accordingly Keep the other values as default and Remember to Press the save setting button appeared in the left side then press SUBMIT buttonĬhanges may save and this may take some time and you may see a progress bar at the bottom.Pre-Shared Key: give alphanumeric more than eight character password for the protection of your wireless network.Pre-Shared Key Format should be Passphrase.WPA Authentication Personal(Pre-Shared Key) should be ticked in.Give a preferred name for your Net work ex : My Network.For the Field “User name” you have to give the user name provided by SLT for youĮx: Then for the Password the Password provideĪfter filling the use name and password in the quick setup.Then we are moving to the Quick setup page and this is the important and starting part of the Configuration. For this we should open up the available web browser you got and type in the default IP address for the router in the address bar.Īnd the Password as “password” for the log in. Now have to configure the router settings from the router page. Hope the router has connected accurately according to the diagram givenīy SLT(Its printed on the bottom side of the box ). …… Still the INT(Internet) Indicator Light Redīecause Haven’t configure the settings yet Indicator Lights blinks still at start up While INT(Internet) Indicator Light Still stays Red because haven’t configure the rougher software yet. PWR(Power) Indicator light changes it’s color from red to green for its normal status, It takes few seconds to start up the router, You may see the indicators are blinking for PWR(Power), INT(Internet),ADSL, LAN1,…., WLAN ADSL. To connect the network cable for Internet we have the LAN1, LAN2, and LAN3 available.Ĭonnect the RJ45 Network cable’s one end as shown to the router and the other end to computers Network port.Ĭonnect the Power Adapter to the Power in and plug it in. We should concern that for this Router/modem and the service provider SLT have their own standards for the network ports.īack panel of the router is shown as belowĪs mentioned in the picture SLT have reserved the LAN4 port for the SLT Peo TV connection.

Here includes the steps for configuring the PROLINK H5004 NK Router / Modem for the SLT Telecommunication line. Technical Note : PROLINK H5004NK Router Configuration for SLT connection I may not responsible for any damage or harm in any way, because I put this article online only as a reading material and for people genuinely need help on this topic.Strongly advising you to take necessary Assistance by Calling SLT hotlines 1212 before you start going further.*** Please read the relevant Important Notice at the bottom of this document as a “Note” before you start or do any modification to your equipment /software.

Prolink h5004nk firmware update